
Aircon is one of the essential facilities to have in your house. An air conditioner will help you to have clean air and maintain the desired temperature in your home. Thus maintaining your air conditioner unit is very important and you can't ignore it. A well-maintained air conditioner will have a longer lifespan, provide clean air and save your pocket to a great extent. There are ten steps that you can use to maintain your air conditioner, but if your air conditioner does not regain its normal functioning, you should seek the help of a professional.
You should never repair your air conditioner when it is running. This unit has some moving parts which are very dangerous, and they can injure you easily. Another risk of working with an air conditioner when the power is on is the risk of electric shock. Make sure you turn the power off at the breaker. This will prevent you from the threat of electric shock and avoid being cut by the moving parts.
As the fan is rotating it may attract some leaves and other debris to the exterior condenser. This may cause your air conditioner not to function well, and you need to make sure you clean them. Removing debris will help the fan to run smoothly and get clean air from the unit. Eliminating waste is very simple, use a screwdriver and loosen the fasters to lift the fan grill from the top of the air conditioner. Using a vacuum cleaner remove all the debris from the unit.
Fins are the most critical part of your air conditioner. This is where all the particles are filtered to have clean air. To clean this part, you will need to use a brush, vacuum cleaner, and garden hose pipe. Start by scrubbing the fins using a brush and then use the vacuum cleaner to blow all the outside dust. To remove the inner dirt, you need to spray the inner side using your garden pipe. Don’t use a pressure washer as this will damage the fins. Using aircon chemical overhaul will help you to remove excess dirt at this part.
In case any fins are bent you should make sure you straighten them to enhance air flow. There are commercially available straightening tools that you can use, but if you don’t have them, you can use a btter knife. Do it gently so that you don’t damage the fins.
After you are done with cleaning your conditioner, you need to clear any bush around the unit to ensure it will not attract debris again. Make sure you cut vegetation and branches at least one meter around the unit and in all directions. When the conditioner is not in use make sure you cover it using plastic to avoid debris from falling to it. Don’t cover the system entirely to prevent rust. Also, don’t cover your air conditioner when in use.
As the soil settles below your unit, it may start to tip, and you need to make sure you bring it to the normal level. When the system is in balanced the compressor may fail very quickly. If you have a heat pump unit, the pad can be a bit sloped to allow defrost to run smoothly.
Another thing that you will need to do when doing maintenance to your air conditioner is cleaning the evaporator coil. To reach it you will need to open some bolts or screws and remove a foil duct after you get to the coil use a brush to scrub the excess dust and spray the coil with coil cleaner. You should not rinse.
The next thing you will do is cleaning you the plugged evaporator drain. This will be necessary so that the drain can flow smoothly. It will also protect your floor as there will be no flooding.
The blower filter should be replaced regularly at least two times in a year. If your area has more dust, you can change it severally within the year. Make sure you change the blower filter using a repair of the same airflow rating.
After doing everything and your furnace is at its normal condition then the final thing to do is to turn it on and start cooling or heating your home.
The above steps will help you to prolong the life of your air conditioner. However, if there are more complicated issues than that you will need to look for a servicing company, an air conditioner servicing company will be well equipped and experienced to handle any problem in your unit.